
Ecumaster ADU Dash Display
from £849.00
Available in 5 or 7 inch variants
High resolution and anti glare screen
Datalogger
Fully user configurable page designs
Easy fitment using can communications
Full spec available here

Ecumaster PMU16 Power Management Unit 16
£829.00
16 High current outputs
No fuses or relays
Simplified wiring
All current information can be sent via can to dash displays to warn of a fault
Safety inertia switch built in , in case of accident
Full spec available here

Ecumaster Emu Black Ecu
£769.00
Top level ecu from ecumaster
Suitable for all sorts of engines up to 12 cylinders
Wideband lambda input
4 Bar map sensor built in
2 EGT probe inputs
Flex fuel capability
Full spec available here

Ecumaster Emu Classic Ecu
£559.00
Can control the most advanced and complex engines up to 12 cylinders
Fuel, ignition and aux control, drive by wire and vvt control
Features more built in value and than any other aftermarket ecu
Built in wideband lambda control
Full spec available here

Ecumaster Can Keyboard
£264.00
Built to work with the PMU
Multiple key layouts available
Built in led's that display switch states
Fully configurable
Full spec available here

Ecumaster Usb to Can
£99.90
The ECUMASTER USB to CAN is a USB interface that allows the user to connect to the CANbus network. It supports CAN 2.0A and CAN 2.0B standards. It is equipped with a LED status diode for fast diagnostic and a 120 Ohm terminator that can be switched on or off to relieve the user from applying external terminators.
This device is used to communicate with the PMU, ADU, Wheelspeed to CAN, Lambda to CAN, Gear Display

Bosch Combined Pressure and Temperature Sensor
£99.50
Genuine Bosch pressure and temperature sensor PST-F 1
Robust design and stainless steel diaphragm making it usable for fuel and oil.
Thread M10x1mm
Supplied with mating connector

Bosch LSU49 Wideband Lambda Sensor
£90.00
This sensor is designed to measure the proportion of oxygen in exhaust gases of automotive engines (gasoline or Diesel). The wideband lambda sensor LSU 4.9 is a planar ZrO2 dual cell limiting current sensor with integrated heater. Its monotonic output signal in the range of lambda 0.65 to air makes the LSU 4.9 capable of being used as a universal sensor for lambda 1 measurement as well as for other lambda ranges. The connector module contains a trimming resistor, which defines the characteristic of the sensor. The main benefit of the LSU 4.9 is the robust design combined with the high Bosch production quality standard.
Sensor is compatible with the EMU Black.
Proper installation and usage of the sensor is required to extend the sensor life. We cannot be held responsible for sensor failures.
Includes Connector

Ecumaster Oil/Fuel Pressure Sensor 10 Bar
£66.00
Pressure sensor suitable for fuel and oil pressure measurements.
Power supply - 5v
Signal 0-10 bar - 0.4-4.5v
Connection - 1/8 NPT
Supplied with connector and terminals .

Bosch Knock Sensor
£40.00
Bosch Knock Sensor
Sensor pinout: Pin 1 Sig+ / Pin 2 Sig- / Pin 3 Scr
Mating connector Included

Bosch 026 Fluid Temperature Sensor
£25.00
This sensor is designed to measure fluid temperatures e.g.oil, water or fuel. This signal may be used as a control value for engine control units or as a measurement value which is logged in a data acquisition system.
M12x 1.5 thread.
Mating connector included